Schulte SRW800 Operator’s Manual With Parts Listing page 66

TROUBLE
Gear Box Leaking
Clutch Slips Excessively
Shear Bolt Breakage
SRW800 07/03
© 2003 Alamo Group Inc.
OPERATION
POSSIBLE CAUSE
1. Damaged oil seal.
2. Bent shaft.
3. Shaft rough in oil seal area.
4. Oil seal installed wrong.
5. Oil seal not sealing in the
housing.
6. Oil level too high.
7. Sand hole in casting.
8. Gasket damaged.
9. Bolts loose.
1. Clutch linings badly worn or
plates warped.
2. Too much power for clutch.
3. Clutch Not Adjusted
4. Oil on facings.
5. Friction facings glazed.
Check slip clutch for seizure
Operation Section 4-36
POSSIBLE REMEDY
Replace seal.
Replace oil seal and shaft.
Replace or repair shaft.
Replace seal.
Replace seal or use a sealant on
OD of seal.
Drain oil to proper level.
Replace castings or gear box.
Replace gasket.
Tighten bolts.
Repair clutch per maintenance
section of manuals.
Reduce ground speed and
material intake.
Adjust Clutch
Replace facings.
Clean with emery cloth.
Settings