(5.1) Connecting The Srw800 A-Frame To The Tractor - Schulte SRW800 Operator’s Manual With Parts Listing

5.1 Connecting the SRW800 A-Frame to the Tractor
1. Make sure the tractor is equipped with the correct
PTO shaft. Change shafts if needed.
2. Shorten or remove the tractor drawbar to avoid
interference when raising and lowering the
implement.
3. Board the tractor and start the engine. Position
the tractor to the windrower with the 3-point lift arms
positioned between the respective set of windorwers
A-frame lift lugs. Note: Set the 3-point lift control
to "Position Control" so that the lift arms maintain
a constant height when attaching the windrower.
See the tractor Operator's Manual for correct
settings when attaching 3-point equipment.
4. Turn off the tractor engine and dismount.
5. One lift arm at a time, align arm end hole between
the set of A-frame lift lugs. Insert hitch pin through
the lug and arm holes and insert retaining pin into
hitch pin.
6. Walk around to opposite side and repeat procedure
for remaining lift arm and hitch pin.
7. Extend or retract 3-point top link to align its end
hole with the holes of the windrowers top link. Insert
the top link hitch pin and insert retaining pin into
hitch pin.
8. Adjust any lower link check chains, guide blocks,
or sway blocks to prevent the windrower from
swaying side to side and possible contact with
tractor rear tires.
DANGER!
Always shut the Tractor completely down, place the transmission in park,
and set the parking brake before you or anyone else attempts to connect
or disconnect the Implement and Tractor hitches.
SRW800 07/03
© 2003 Alamo Group Inc.
OPERATION
(S3PT-15)
Operation Section 4-11