Slipclutch - Schulte SRW800 Operator’s Manual With Parts Listing

MAINTENANCE
SLIPCLUTCHES
The FT clutch utilizes a Belleville spring to provide a
consistent torque setting during the life of the friction
lining. The spacer ring ensures the accuracy of the
spring tension setting.
The clutch torque setting is stamped on the face of
the flange yoke between the bolts.
Disassembly
Fully loosen all four socket head screw
Remove the taper pin.
Loosen the bolts evenly and progressively (i.e. do
not remove each nut completely in sequence) to
uniformly reduce the spring load.
Disassemble the clutch completely.
Check the condition of all components.
New friction linings are 3.2 mm thick. Replacement
is recommended when linings wear below a
thickness of 2.5 mm. Clean up the metal contact
surfaces with brake cleaner and a wire brush, if
necessary.
Maintenance Section 5-4
SRW800 07/03
© 2003 Alamo Group Inc.