External I/O Module; External I/O Module Type; Mounting Procedure - Mitsubishi 900 Series User Manual

6 HANDLING

6.9 External I/O Module

6.9.1 External I/O module type

6.9.2 Mounting procedure

6 - 19
The external I/O module is connected with the ten-key panel (A8GT-TK) or keyboard to
receive up to 8/64 points of inputs or provide up to 16 points of outputs.
Refer to the GT Designer Help Function for details.
The following external I/O module is available.
Type
A8GT-50KBF
For A95 GOT
For A956WGOT
When using the A8GT-50KBF, use the ROM_BIOS of SW1D5C-GOTRE-
PACK H version or later (ROM_BIOS G version or later).
For details of the External I/O module specifications, refer to the A8GT-50KBF
type External I/O module User's Manual.
External I/O module
1) Thread A8GT-50KBF mounting screw holes
in the control box or the like. (2- 3.5
mounting holes)
The A8GT-50KBF's GOT connection cable
is 50cm long.
Install the A8GT-50KBF within this distance
so that the GOT-end connector of the cable
may be fitted into the GOT's connector.
When mounting the A8GT-50KBF on the
back of control box door, exercise care to
avoid screw holes passing through the
control box surface.
2) Tighten the mounting screws to the
specified torque range 39 to 59N
3) Plug the GOT side connector of the A8GT-
50KBF to the option unit of the GOT.
MELSEC-GOT
Description
cm.
6 - 19