Mitsubishi 900 Series User Manual page 32

4 NAMES OF THE PARTS AND THEIR SETTINGS
13)
No. Name
1) Display section
2) Reset button
3) Compact flash card access switch
4) Compact flash card LED
5) RS-232C interface
6) Communication module interface
7) Compact flash card slot
8) Option module interface
9) Slot cover
10) Memory board slot
11) Communication board slot
12) Terminal block
13) Mounting fixture fitting portion
14) Ground terminal
Bus connection board setting switch
15)
confirmation hole
4 - 2
(2) Names of the Parts and Their Settings of the A956WGOT are indicated
below.
1)
13)
8)
Shows the screen
Used to reset the hardware of the GOT (invalid for bus connection)
Used to set the condition of access to the compact flash card when it is
loaded during power-on (Factory-set to OFF)
OFF :Access from GOT to compact flash card inhibited
ON :Access from GOT to compact flash card enabled
(When a memory card interface unit is used, a compact flash card cannot
be used. Therefore, turn this switch OFF.)
Indicates whether the compact flash card may be loaded/unloaded or not
OFF :Compact flash card may be loaded/unloaded
(When switch 3 is OFF)
ON :Compact flash card must not be loaded/unloaded
(When switch 3 is ON)
For connection of personal computer
For connecting the bar code reader
Interface for communication module loading
Slot for Compact flash card loading
For connection Printer I/F module, Memory card I/F module, External I/O
module
Cover of the memory board slot and the communication board slot
Slot for memory board loading
Slot for communication board loading
For power input
For mounting fixture fitting
For earthing (For safety, please make sure to ground this terminal.)
For confirming the extension number of the I/O slot number set with the bus
connection board
(If you are not using the A9GT-50WBUSS, it is possible to attach the seal
included with the GOT main unit to cover the hole.)
5) 6) 9)
14) 12)
15)
11)
10)
Description
MELSEC-GOT
7)
4)
3)
2)
4
4 - 2