External I/O Module; External I/O Module Type; Mounting Procedure - Mitsubishi A950GOT User Manual

6.9 External I/O Module

The external I/O module is connected with the ten-key panel (A8GT-TK) or keyboard to receive up to 8/64
points of inputs or provide up to 16 points of outputs.
Refer to the following manual for details of the corresponding functions.
• When GT Designer is used
• When GT Designer2 is used : GT Designer2 Version
6.9.1

External I/O module type

The following external I/O module is available.
Type
A8GT-50KBF
6.9.2

Mounting procedure

• When using the A8GT-50KBF, use the ROM_BIOS of SW1D5C-GOTRE-PACK H version or later
(ROM_BIOS G version or later). (GT Works2 and GT Designer2 are compatible, starting with the
initial products (Version 1.00A).)
• For details of the External I/O module specifications, refer to the A8GT-50KBF type External I/O
module User's Manual.
6 - 26
6.9 External I/O Module
6.9.1 External I/O module type
: Help function of GT Designer
External I/O module
1) Thread A8GT-50KBF mounting screw holes in the control
box or the like. (2-
The A8GT-50KBF's GOT connection cable is 50cm long.
Install the A8GT-50KBF within this distance so that the
GOT-end connector of the cable may be fitted into the
GOT's connector.
When mounting the A8GT-50KBF on the back of control
box door, exercise care to avoid screw holes passing
through the control box surface.
2) Tighten the mounting screws to the specified torque range
39 to 59N
3) Plug the GOT side connector of the A8GT-50KBF to the
option unit of the GOT.
Get other manuals https://www.bkmanuals.com
Reference Manual
Description
3.5 mounting holes)
cm.