Set The Gpib Address - Tektronix Keithley DMM7510 User Manual

Section 3: Using a remote interface Model DMM7510 7½ Digit Multimeter User's Manual
Figure 15: Instrument GPIB connections

Set the GPIB address

The default GPIB address is 16. You can set the address from 1 to 30 if it is unique in the system.
This address cannot conflict with an address that is assigned to another instrument or to the
GPIB controller.
GPIB controllers are usually set to 0 or 21. To be safe, do not configure any instrument to have an
address of 21.
The instrument saves the address in nonvolatile memory. It does not change when you send a reset
command or when you turn the power off and on again.
To set the GPIB address from the front panel:
1. Press the MENU key.
2. Select Communication.
3. Select the GPIB tab.
4. Set the GPIB Address.
5. Select OK.
You can also set the GPIB address using remote commands. Set the GPIB address with the SCPI
command :SYSTem:GPIB:ADDRess or the TSP command gpib.address.
3-4 DMM7510-900-01 Rev. C / September 2019