View Measurement Data - Tektronix Keithley DMM7510 User Manual

Model DMM7510 7½ Digit Multimeter User's Manual
To change the measure settings:
1. Press the MENU key.
2. Under Measure, select Settings.
3. Select Display Digits.
4. Select 3.5 Digits.
5. Press the HOME key. The measurement now shows 3½ digits.
To make a single measurement:
1. Press the front-panel TRIGGER key for a few seconds.
2. Select Manual Trigger Mode.
3. Press the TRIGGER key to initiate a single reading using the selected measure function.

View measurement data

You can view data from the reading buffers through the front panel using the Reading Table. The
Reading Table displays the following information:
•
Index: The sequential number of the reading.
•
Time: The date and time of the reading.
•
Reading: The data that was measured.
•
Extra: Only displayed for buffers that are set to Full. The extra value that is stored with a reading,
such as the ratio component of a DCV ratio measurement.
DMM7510-900-01 Rev. C / September 2019
Figure 23: Basic measurement test results
Section 4: Making basic front-panel measurements
4-3