Tektronix Keithley DMM7510 User Manual page 93

Section 10: Capturing and analyzing waveforms
Using SCPI commands
You may need to make changes so that this code will run in your programming environment.
Send the following commands:
Command
*RST
:SENS:DIG:FUNC "CURR"
:SENS:DIG:VOLT:RANG 1
:SENS:DIG:VOLT:SRAT 500e3
:SENS:DIG:VOLT:APER AUTO
:SENS:DIG:COUN 50
:TRAC:POIN 50
:TRAC:CLE
:TRAC:TRIG:DIG
:TRAC:DATA? 1, 50, "defbuffer1", READ
:TRAC:DATA? 1, 50, "defbuffer1", REL
10-14
Figure 46: Inductor current linearity results at 8 Ω
Model DMM7510 7½ Digit Multimeter User's Manual
Description

Reset the DMM7510.

Set the instrument to measure digitize current.

Set range to 1 A.

Set the sample rate to 500,000.

Enable automatic aperture.

Set the sample count to 50.

Set defbuffer1 to store 50 points.

Clear defbuffer1.

Make digitize measurements.

Retrieve the readings from the buffer.

Retrieve the relative timestamps from the buffer.
DMM7510-900-01 Rev. C / September 2019