Model DMM7510 7½ Digit Multimeter User's Manual
4-wire resistance measurements with offset compensation
This application demonstrates how to use the DMM7510 to measure the resistance of a device or
component. You can make this measurement from the DMM7510 front panel or over the remote
interface using SCPI code or TSP code. For information about setting up remote communications,
see
Remote communications interfaces
For this application, you will:
•
Reset the instrument.
•
Select the 4-wire resistance function. This method eliminates the effect of the lead resistance on
measurement accuracy.
•
Enable offset compensation.
•
Make measurements from the front panel or the remote interface.
DMM7510-900-01 Rev. C / September 2019
Figure 28: Front-panel connections for 4-wire resistance measurements
Figure 29: Rear-panel connections for 4-wire resistance measurements
Section 6: Measuring 4-wire resistance with offset compensation
(on page 3-1).
6-3