Tektronix Keithley DMM7510 User Manual page 38

Section 3: Using a remote interface Model DMM7510 7½ Digit Multimeter User's Manual
Verify the instrument through the Keithley Communicator:
1. Set the instrument to use the SCPI command set. Refer to How do I change the command set?
(on page 11-3) for instruction.
2. Select Start > Keithley Instruments > Keithley Communicator.
3. Select File > Open Instrument to open the instrument you just named.
Figure 20: Keithley Communicator Open an Instrument
4. Select OK.
5. Send a command to the instrument and see if it responds.
If you have a full version of NI-VISA on your system, you can run NI-MAX or the VISA Interactive
Control utility. See the National Instruments documentation for information.
3-12 DMM7510-900-01 Rev. C / September 2019