Powering Device Via Mikroprog - mikroElektronika mikroProg for PIC Manual

One of key benefits on mikroProg is power supply mode which
can be activated from mikroProg Suite for PIC
mikroProg Suite for PIC window (MCU INFO button) you can set
power supply voltage in range from
up to 250mA. When you select MCU family under mikroProg Suite
for PIC window, mikroProg will automatically detect which MCU is
in use and it will set maximum power supply which can be used.
Voltage supply value can be set by moving slider under mikroProg
Suite for PIC window, Figure 4-1.
To enable power supply, first set desired voltage and then click on
check box "Power board from programmer".
software. Under
1.8V to 5V with output current
02
Figure 4-1: Voltage options
Setting supply voltage value from 1.8 to 5V (max 250mA)
01
Check box for enabling supply voltage from programmer
02
Box with selected supply voltage
03
Page 11
01 03