Grandstream Networks GRP2615 Administration Manual page 56

BLF Pickup Sound
Only list
Local Call Recording
Feature
Replace the oldest call
record
Download Local Call
Recordings
Enable IM Popup
Instant Message
Popup Timeout
Play Tone On
Receiving IM
Allow Incoming Call
Before Ringing
User-Agent Prefix
Hide BLF Remote
Status
Show SIP Error
Response
Enable Missed Call
Notification
Enable Call
Completion Service
Enable Incoming Call
Popup
extensions in the list [BLF Pickup Sound Only List]. The default setting is
"Allow Except".
Configures play BLF sound notification only for the list below.
Gives the ability to record calls locally while on the call screen.
The default setting is "Disabled".
When enabled, the oldest call record will be replaced with the newest one
when the storage is full. If the option is disabled, the call recording feature
will stop recording automatically. Default is "Disabled".
When there are recordings presented, you may download them here.
If set to "No", phone will not show a pop up when receiving an IM. The default
setting is "Yes".
Configures the number of seconds that the message will remain on screen.
The valid range is 10 – 900. The default setting is "10".
If enabled, phone will play a short tone when receiving an IM during idle
state. Default setting is "Disabled".
This allows incoming calls after dialed but before ringing. This can be used
under custom user configuration based on need. Default setting is "No".
Configures the prefix in the User-Agent header.
Allows users to hide the Caller ID from showing at the BLF VPK.
•
No: The VPK will flash between the Caller ID and the BLF account.
•
Yes: The VPK will stay under the monitored account and only notify that
there is an incoming call.
The default setting is "No".
Shows SIP error response information on LCD screen. The default setting is
"Yes".
Allows users to show/hide the notification popup for missed calls.
The default setting is "Yes".
Note: Currently the manually rejected calls are counted as missed calls.
When the automatic redial and call completion service are enabled, and the
user makes a call to callee, when the callee is busy at the moment, phone
will monitor callee's status. Once the callee is available, phone will ask if
user wants to redial again. The default setting is "No".
If set to "Yes", phone will pop up an incoming call window to notify the call.
If set to "No", there will be no notification pop up on LCD when there is an
incoming call. This way users will not get disrupted by unexpected popup
call but still get notified by the flashing line LED.
GRP2615 Administration Guide
Version 1.0.0.31
P a g e | 56