Grandstream Networks GRP2615 Administration Manual page 53

Live DialPad Expire
Time
Last Call Forward All
Enable Automatic
Redial
Automatic Redial
Times
Automatic Redial
Interval
Bypass Dial Plan
Through Call History
and Directories
Disable Call Waiting
Disable Call Waiting
Tone
Ring For Call Waiting
Disable Busy Tone on
Remote Disconnect
Disable Direct IP Call
Use Quick IP Call
mode
Disable Conference
Sets the Live DialPad expire time before initiating the call using Live DialPad
feature. Interval is between 2s and 15s. Default value is 5s.
Configures to enable storing the last input number when entering number in
the call screen after pressing the ForwardAll softkey. Default is "No".
Enables the phone to redial automatically when called number is busy.
If enabled, the phone will prompt the user to start "automatic redial" or no. If
yes, the phone will redial called number several times [Automatic Redial
Times] with [Automatic Redial Interval] between each call. The user is
guided via different prompts on phone's LCD displaying number of remaining
attempts, count-down to initiate next auto redial and allowing user to
manually initiate the call without waiting for the specified interval [Automatic
Redial Interval]. The phone will stop automatic redial after successful
attempt (called party not busy) or after unsuccessful attempts [Automatic
Redial Times]. The default setting is "No".
The number of times to attempt to call using Automatic Redial feature. The
valid range is 1 – 200. The default value is "10".
The interval between each call attempt using Automatic Redial feature. The
valid range is 1 – 360. The default value is "10".
Enable/Disable the dial plan check while dialing through the call history and
any phonebook directories. The default setting is "No".
Disables the call waiting feature.
The default setting is "No".
Disables the call waiting tone when call waiting is on.
Default setting is "No".
Disables / enables ringing instead of playing call-waiting tone when audio is
on handset or headset. The default setting is "No".
Disables the busy tone heard in the handset when call is disconnected
remotely. The default setting is "No".
Disables Direct IP Call.
The default setting is "No".
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address.
To dial quick IP call, off hook the phone, press # to switch to "Direct IP Call"
mode and dial XXX (X is 0-9 and XXX <=255), phone will make direct IP call
to aaa.bbb.ccc.XXX where aaa.bbb.ccc comes from the local IP address
REGARDLESS of subnet mask. XX or X are also valid so leading 0 is not
required (but OK). No SIP server is required to make quick IP call. The
default setting is "No".
Disables the Conference function.
GRP2615 Administration Guide
Version 1.0.0.31
P a g e | 53