Grandstream Networks GRP2615 Administration Manual page 45

Send Anonymous
Anonymous Call
Rejection
Auto Answer
Refer-To Use Target
Contact
Transfer on
Conference Hang-up
Disable Recovery on
Blind Transfer
Blind Transfer Wait
Timeout
No Key Entry Timeout
Key As Send
On Hold Reminder
Tone
RFC2543 Hold
•
Log incoming/Outgoing Only (missed calls NOT recorded)
•
Disable Call Log
The default setting is "Log All Calls".
If set to "Yes", the "From" header in outgoing INVITE messages will be set to
anonymous, blocking the Caller ID to be displayed. Default is "No".
If set to "Yes", anonymous calls will be rejected. The default setting is "No".
If set to "Yes", the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep. Default setting is "No".
If set to "Yes", the "Refer-To" header uses the transferred target's Contact
header information for attended transfer. The default setting is "No".
If set to "Yes", when the phone hangs up as the conference initiator, the
conference call will be transferred to the other parties so that other parties
will remain in the conference call. The default setting is "No".
Disables recovery to the call to the transferee on failing blind transfer to the
target. The default setting is "No".
Notes:
1) This feature only applies to blind transfer;
2) This feature depends on how server handles transfer. If there is any
NOTIFY from server, this feature won't take effect. If server responds 4xx,
phone should try to recover regardless of this option.
3) During blind transfer, after transferor received 200/202 for REFER, but
there is no NOTIFY from server after 7 seconds, transferor will decide to
recover the call with transferee or not depending on the options. This is the
only case that this option will be applied.
Defines the timeout (in seconds) for waiting SIP frag response in blind
transfer. Valid range is 30 to 300. Default setting is "30".
Defines the timeout (in seconds) for no key entry. If no key is pressed after
the timeout, the digits will be sent out. The default value is 4 seconds. The
valid range is from 1 to 15.
Allows users to configure either the "*" or "#" keys as the "Send" key. Please
make sure the dial plan is properly configured to allow dialing * and # out.
The default setting is "Pound (#)".
If set to "Enabled", phone will play a reminder tone when it has a call on hold.
The default setting is "Enabled".
Allows users to toggle between RFC2543 hold and RFC3261 hold. RFC2543
hold (0.0.0.0) allows user to disable the hold music sent to the other side.
RFC3261 (a line) will play the hold music to the other side. The default setting
is "No".
GRP2615 Administration Guide
Version 1.0.0.31
P a g e | 45