Endless Pools Streamline Installation, Operations And User's Manual page 29

Fig. 70
At the rear of the pool, apply silicone to the ends of each cop-
ing section to seal the gap between the coping and top flange.
Position the rear corner pieces in the rear corners of the pool. Use
the provided 11/64" (4mm) drill bit to drill through the alumi-
num coping into the top flange of the pool using the pre-drilled
holes in the corner pieces as a template. Use the ¾" (19mm) truss
head screws located in the coping corner hardware bag to secure
each corner. Fig.71.
Apply silicone to the seam between the sections of coping on
the side walls. Center a trim strip on each seam and adhere the
trim strip to the aluminum coping. Fig. 71
Fig. 71
28