Table of Contents
Advertisement
Quick Links
Pool Series & Spa Series Winterization
Overview:
NOTICE
A pool left inactive during the winter months is susceptible to damage from freezing water. The purpose of winterizing
the pool is to ensure that the PVC plumbing lines and water quality components (pump, filter, heater, UV, etc.) do not
sustain freeze damage over the winter months. Each pool may potentially have a different equipment configuration
and site conditions vary, but the concepts are still the same. The overall goal is to isolate the water in the pool from the
plumbing systems and then remove all of the water from these lines.
Depending on the pool design, removing a large volume of water from the pool is not recommended or necessary. In
most cases, gravity will suffice to rid the pipes of water, although in some instances, a wet/dry vacuum or a small air
compressor with a quick coupler fitting may be necessary to flush out the lines. When using a compressor, take care not
to exceed 10 psi in the system.
Table of Contents
Winterizing Endless Pools Original Series and WaterWell . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Winterizing Endless Pools StreamLine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Winterizing Endless Pools Spa Series . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Winterizing Endless Pools Fiberglass Pool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Endless Pools
It is imperative that a pool be properly winterized if it will be susceptible to freezing
temperatures. The pool and its components will be damaged if it is not done properly.
The following covers all but the most unique of installations.
Freeze damage is NOT covered under warranty. Endless Pools is not responsible for
damage to the pool or its components as a result of freezing temperatures.
The best way to ensure that the pool is properly winterized is to employ a local Pool/
Spa professional to perform the winterization procedure.
Service Instruction
1
D90010_en 1122
Advertisement
Table of Contents
Related Manuals for Endless Pools Winterizing Pool Series
Summary of Contents for Endless Pools Winterizing Pool Series
- Page 1 Winterizing Endless Pools Fiberglass Pool ........
- Page 2 Plug with #10 rubber expanding winter plug. If a standard thru-wall fitting has been used, a 1.5” threaded plug with an o-ring can be used. For Endless Pools original series, the suction(s) will either be behind the 45 degree shroud on the right side of the propulsion housing or under the rear base assembly.
- Page 3 “non-chlorine” floater that will slowly disperse the contents over the course of the winter. Generally speaking, Endless Pools tend to be much smaller than what the industry would consider a small pool, so usually the kit labeled for the smallest gallonage will suffice.
- Page 4 “non-chlorine” floater that will slowly disperse the contents over the course of the winter. Generally speaking, Endless Pools tend to be much smaller than what the industry would consider a small pool, so usually the kit labeled for the smallest gallonage will suffice.
- Page 5 Pool Series & Spa Series Winterization Service Instruction Winterizing Endless Pools Spa Series Refer to the instructions below for legacy spa series models and the following page for Fitness System models. Legacy Spa Series Models (shipped between 2010 - 2016) 1.
- Page 6 Pool Series & Spa Series Winterization Service Instruction Endless Pools Fitness System Models (shipped 2017- Present) 1. Turn off the circuit breaker or electrical disconnect to the swim spa. 2. Drain the swim spa. 3. Remove filters and vacuum filter plumbing to clear all water from those lines. Clean and store filters in a dry place 4.
- Page 7 “non-chlorine” floater that will slowly disperse the contents over the course of the winter. Generally speaking, Endless Pools tend to be much smaller than what the industry would consider a small pool, so usually the kit labeled for the smallest gallonage will suffice.
- Page 8 13. Place cover pump on top of cover to remove any water that may accumulate. 14. Monitor the amount of snow/water on top of the cover during the winter. Remove excess snow and/or move cover pump as necessary. Endless Pools D90010_en 1122...
Need help?
Do you have a question about the Winterizing Pool Series and is the answer not in the manual?
Questions and answers