Control Cables Interconnection - ABB MegaFlex 1000 UL S1 Installation Manual

26/54

4.7.3 Control cables interconnection

Note!
All the cables interconnection must be performed only by an ABB Service Technician!
MegaFlex 1000 to 1600 - Control cables interconnection
Connector XD
(46 poles)
Board
P25 - IM0323
Connectors Interface
XD
(46 poles)
Module not available in the
MegaFlex 1000 - 1100 - 1200
Power Section cabinet
Fig. 4.7.3-1 MegaFlex 1000 to 1600 – Control cables interconnection
Connection
XD – HAN Connector male (46 p.)
Fig. 4.7.3-2 Connection HAN connector
6x – Connector 4 wires
6x – Connector 26 poles
2x – Connector J45
F ROM PM TO EL
J20 J17
TO PM FRO M EL
IM032 3 - 8600268459P
B AR CODE
Board P25 - IM0323 - Connectors In terface
In/Out Section cabinet
From (already connected)
"In/Out Section" cabinet
Note! All these connections must be performed only by an ABB Service
Technician!
Proper dressing needs to be done for each cable assembly in order to reduce
the stress.
All the cables must be sufficiently (at least 4"/10cm) away from all live parts.
Cable binders used to support the wiring must not be overly tightened.
"In/Out Section" cabinet
"In/Out Section" cabinet
"In/Out Section" cabinet
MegaFlex 1000 to 1600
J10 J9 J8 J3 J2 J1
J21 J18
J 10pm J9 pm J 8pm J 3pm J2pm J1 pm
Connector J45 Connector 4 wires
2x / 1_CAN & J2_CAN 6x / J1 - J2 - J3 - J8 - J9 - J10
Connecting to
"Power Section" cabinet - HD Connector
"Power Section" cabinet / Board "P25 - IM0323"
J1 - J2 - J3 - J8 - J9 - J10
"Power Section" cabinet / Board "P25 - IM0323"
J16 - J17 - J18 - J19 - J20 - J21
"Power Section" cabinet / Board "P25 - IM0323"
J1_CAN and J2_CAN
UPS Installation Guide / REV-A
J19 J16
Connector 26 poles
6 x / J16 - J17 - J18 - J19 - J2 0 - J21