Inter Cabinet Connections - ABB MegaFlex 1000 UL S1 Installation Manual

23/54

4.7 Inter cabinet connections

Note!
The "Power Section cabinet" and "In/Out Section cabinet" must be installed on levelled floor.
Be aware of the heavy weight of the UPS cabinets, pay attention when moving the UPS cabinet.
Take care not to damage the UPS cabinets when moving by forklift.
MegaFlex 1000 to 1600 Preparation for interconnection of UPS cabinets
MegaFlex 1000 to 1600 is delivered split into two cabinets, "Power Section cabinet" and "In/Out Section
cabinet" (cabinet with Control Panel).
Align them together with the "In/Out Section cabinet" on the right side (cabinet with Control Panel).
Pay attention, that no loose cables are trapped when pushing the cabinets together.
For "Power Section cabinet" proceed in the following way:
- Remove the front protection panels "A and B".
- Remove the top panel "C".
For "In/Out Section cabinet" proceed in the following way:
Open the doors "D".
-
Open the Electronic Module "E".
-
Remove the front protection panels "F".
-
Remove the top panel "G".
-
Module not available in the
MegaFlex 1000 - 1100 - 1200
A
Once the 2 cabinets have been positioned and the various operations described in Fig. 4.7 have been carried out,
you can proceed to the various interconnections described in Section 4.7.1, 4.7.2, 4.7.3 and 4.7.4.
Note!
Performed all the interconnection procedures, describe in Section 4.7.1, 4.7.2, 4.7.3 and 4.7.4, you
must reassemble all the protections previously removed.
Power Section cabinet
Control cables connection
(see Section 4.7.3)
B
Fig. 4.7-1 MegaFlex 1000 to 1600 – Cabinets positioning and interconnection
MegaFlex 1000 to 1600
C
Lower closures
with air inlet grids
see Section 4.7.4)
Junction metal
connection cabinets
(see Section 4.7.1)
UPS Installation Guide / REV-A
Bus bars interconnection
(see Section 4.7.2)
D
E
Lower closures
with air inlet grids
see Section 4.7.4)
F
G
In/Out Section cabinet
D