ABB MegaFlex 1000 UL S1 Installation Manual page 22

22/54
Anti-humidity & corrosion devices
D
Power Section
A
2x
B
B
B
B
B
C
HUMID ITY I NDICATOR
80 %
70 %
60 %
A
50 %
40 %
3 0 %
20 %
MegaFlex 1000 to 1600
Fig. 4.6-3
Location of the "Anti-Humidity & Corrosion devices"
Protective foil
PROTECTIVE
FOIL
to remove
as indicated
in the label
Fig. 4.6-4 MegaFlex 1000 to 1600 - "Power Section cabinet"
Location of the "Protective Foil"
cabinet
D
A
2x
B
2x
B
B
B
B
B
C
B
DESICCANT
PROTECTIVE FOIL
to remove
as indicated
in the label
MegaFlex 1000 to 1600
The package of the MegaFlex 1000 to 1600 includes
"Anti-Humidity & Corrosion devices" against the
formation of humidity and corrosion during the
transportation and the storage of the UPS.
"Anti-Humidity & Corrosion devices" components for
In/Out Section
cabinet
any cabinet ("Power Section cabinet" and "In/Out
Module cabinet"):
A Humidity indicator
B Desiccant bag (9 pcs.)
C VCI foil base
D PE stretch foil
2x
B
B
B
MegaFlex 1000 to 1600 is provided with a "Protective
Foil", on the roof and door/front panels, to prevent
material from falling into UPS.
UPS Installation Guide / REV-A
Warning!
It's mandatory to remove the "Anti-
Humidity & Corrosion devices" during
the unpacking of the UPS!
Humidity indicator
Before removing the devices "C - VCI foil
base" & "D - PE stretch foil", check the
status of the "A - Humidity indicator".
10% to 70%:
The UPS can be commissioned.
80%:
The UPS shall not be commissioned.
Please contact your ABB Service Centre.
Warning!
It's mandatory to
"Protective Foil" but only just before
the first start-up of the UPS as
indicated in the appropriate label!
The removal of the "Protective Foil"
should be performed only by an ABB
Service Technician!
Packing material recycling!
ABB, in compliance with environment
protection, uses only environmentally
friendly material.
UPS packing materials must be recycled
in compliance with
regulations.
remove the
all applicable