Operation; Control Panel; Selection Keys - ABB PowerValue 11 RT G2 User Manual

4 O P E R AT I O N
—

4 Operation

This chapter describes how the UPS is operated through the
LCD.
The user can:
• Operate the LCD
• Start up and shut down the UPS (excluding the
commissioning start up)
• Operate additional SNMP adapters and their software
—

4 .1 Control panel

—
4.1-1:
Control panel
LCD
Selection
keys
—
4.1-1
4 .1 .1
—
Table 2: UPS selection keys
Button
H
M

Selection keys

Function Illustration
• Turn on the UPS: Press and hold ON/Mute button for at least 2 seconds to turn on the UPS.
• Mute the alarm: When the UPS is on battery mode, press and hold this button for at least 5 seconds to disable or
ON/Mute
enable the alarm system. Not applicable to situations when warnings or errors occur.
Button
• Up key: Press this button to display previous selection in UPS settings mode.
• Switch to UPS self-test mode: Press and hold ON/Mute button for 5 seconds to enter UPS self-testing while in AC
mode, ECO mode, or converter mode.
• Turn off the UPS: Press and hold this button at least 2 seconds to turn off the UPS. UPS will be in standby mode
OFF/Enter
under power normal or will transfer to bypass mode, if the bypass enable is set when this button is pressed.
Button
• Confirm selection key: Press this button to confirm selection in UPS settings mode.
• Switch LCD message: Press this button to change the LCD message for input voltage, input frequency, battery
voltage, output voltage and output frequency. It will revert to default display after 10 s of no input.
Select
• Settings mode: Press and hold this button for 5 seconds to enter UPS settings mode when UPS is in standby mode
Button
or bypass mode.
• Down key: Press this button to display next selection in UPS settings mode.
• Switch to bypass mode: When the main power is normal, press ON/Mute and Select buttons simultaneously for 5
ON/Mute +
seconds. Then UPS will enter to bypass mode. This action will be ineffective when the input voltage is out of
Select Button
acceptable range.
OFF/Enter +
• Switch LCD screen 90°: Press Off/Enter and select buttons simultaneously 5 second. The UPS LCD screen will rotate
Select Button 90°.
The user-friendly control panel has two parts:
• Selection keys
• Power management LCD (PMD)
VAC
H %
z
VDC
15