Table of Contents
Advertisement
8.5
Changing the material nozzle and the air nozzle
Removing the nozzles
1.
Interrupt operation (
2.
If necessary, secure the material pressure pump or pressurised material container for the
spray medium against a restart.
Fig. 10: Removing the nozzles
3.
Loosen the cap nut ( Fig. 10/1) and remove together with the air nozzle ( Fig. 10/2).
4.
Actuate and hold the pull lever ( Fig. 10/4).
5.
Unscrew the material nozzle ( Fig. 10/3) with a respective fork wrench.
Always replace the material nozzle ( Fig. 10/3) and the material needle ( Fig. 10/5) at
the same time.
Attaching the nozzles
1.
Actuate and hold the pull lever ( Fig. 10/4).
2.
WARNING!
Risk of injury through the use of incorrect spare parts!
Tighten the material nozzle ( Fig. 10/3) with suitable fork wrench.
3.
Release the pull lever ( Fig. 10/4).
4.
Reinsert the air nozzle ( Fig. 10/2) in the cap nut ( Fig. 10/1) and tighten.
GB–32
Operating instructions
Ä Chapter 7.5 'Shutting down' on page 25).
T-Dok-692-GB-Rev.0
mail@krautzberger.com, www.krautzberger.com
Advertisement
Table of Contents
