Customer Care - Krautzberger HS 30 Operating Instructions Manual

Spray pattern Error
Spray pattern too thin
Material jet comes out
in spurts or rapid
bursts
Leakage on the
clamping screw
Material nozzle drips
9.1

Customer Care

Krautzberger GmbH
Customer service
Stockbornstr. 13
65343 Eltville am Rhein
+49 6123 - 698151
customercare@krautzberger.com
GB–40
Operating instructions
Cause
Cap nut loose
n
Insufficient mate-
n
rial supply
Blocked material
n
path
Loose or dam-
n
aged material
nozzle
n Worn needle seal
n Needle seal
defective
n Worn or damaged
material needle
Dirty or damaged
n
material nozzle
T-Dok-692-GB-Rev.0
Remedy
Tighten the cap nut
n
Increase the material
n
supply
Clean
n
Tighten or replace (
n
Ä Chapter 8.5
'Changing the material
nozzle and the air
nozzle' on page 32).
n Replace the needle
Ä Chapter 8.7
seal (
'Changing the seals'
on page 35).
n Replace the needle
Ä Chapter 8.7
seal (
'Changing the seals'
on page 35).
n Change the material
needle ( Ä Chapter 8.6
'Changing the material
needle' on page 33).
Clean ( Ä Chapter 8.4
n
'Cleaning the hand-held
spray gun' on page 29)
or replace (
8.5 'Changing the
material nozzle and the
air nozzle' on page 32)
the material nozzle.
mail@krautzberger.com, www.krautzberger.com
Ä Chapter