Table of Contents
Advertisement
7.3
Changing the material nozzle and the air nozzle
Remove nozzles
1.
Clean automatic spray gun (
Fig. 8: Changing the nozzles
2.
WARNING!
The closing piece ( Fig. 8/5) is under spring force!
Carefully unscrew the closing piece ( Fig. 8/5).
3.
Loosen clamping nut ( Fig. 8/1).
4.
Remove the air nozzle ( Fig. 8/2).
5.
Unscrew fluid nozzle ( Fig. 8/3).
Always change the fluid nozzle ( Fig. 8/3) and fluid needle ( Fig. 8/4) at the same time.
Attaching the nozzles
1.
Tighten the fluid nozzle ( Fig. 8/3).
2.
Attach the air nozzle ( Fig. 8/2) and tighten it with the clamping nut ( Fig. 8/1).
3.
Screw on the closing piece ( Fig. 8/5).
GB–30
Operating instructions
Ä Chapter 7.2 'Cleaning automatic spray gun' on page 29).
T-Dok-665-GB-Rev. 0
mail@krautzberger.com, www.krautzberger.com
Advertisement
Table of Contents
