Table of Contents
Advertisement
8. STATE Section
The STATE section contains states and settings that are unrelated to audio I/O and clock. It can be used
to configure presets, dark mode, level meters, and remote control.
A notification (orange) is shown when a preset is modified, no IP address was assigned to the web
remote or any dark mode is active.
8.1. Presets
Any change in the device configuration is persistent. After a power loss, the device will revert back to its
last state. Additionally, the AVB Tool can save fifteen states in presets numbered 1-15. After a preset is
loaded, any change in the configuration will result in an unsaved changes state.
The internal preset storage is not affected when the device firmware is updated to a newer
firmware version. Moreover, recalling the factory default preset does not delete any other
saved preset.
Settings that are not saved in a Preset
The following settings are not saved in a preset:
• Auto-lock
• Lock code
• Remote control
Quick Start Preset
Pressing and holding the first (top) button next to the display while powering on the AVB Tool (and until
the channel LEDs start flashing) activates the Quick Start Preset. Loading this preset does not affect any
internally saved presets until it is saved.
The quick start preset is identical to the factory default preset, but it adds the following routings:
From analog input 1 to 4 to
• MADI Coaxial Ch. 1 - 4
RME AVB Tool User's Guide
Representation of an unsaved preset on the device.
8. STATE Section | 28
Advertisement
Table of Contents
