Table of Contents
Advertisement
235-200-150
October 2005
Replace a DVD Drive ( Netra
4.17
OVERVIEW
This procedure is used to replace the DVD drive on a Netra 240 Administrative
Workstation. The DVD drive in the Netra 240 is not hot-swappable. The AW must be
powered down and the power input cables disconnected before replacing the DVD
drive.
Caution: The DVD drive contains a laser device. If the replacement
procedures are not followed, the user risks being exposed to radiation.
PROCEDURE
1.
Halt the AW (see "Halt the Administrative Workstation," Procedure 4.2).
2.
Remove power to the AW (see "Remove Power to Administrative Workstation
Units (Netra 240)", Procedure 4.9).
3.
Grip the bezel at the two finger holds and rotate it down to open (see Figure
4.17-1).
Figure 4.17-1 — NETRA 240 Front Fingerholds
4.
Unclip the catches that fasten the DVD drive to the chassis (see Figure 4.17-2).
1. Registered trademark of Sun Microsystems, Inc.
Issue 8.00O
ADMINISTRATIVE WORKSTATION MAINTENANCE
1
240)
Procedure 4.17
Page 4.17-1
Advertisement
Chapters
Table of Contents
