Restore Administrative Workstation - Lucent 5ESS DRM User Manual

235-200-150
January 2003
4.3

Restore Administrative Workstation

OVERVIEW
This procedure provides the steps to take when the AW locks up and fails to respond
to input commands or pokes entered on the MCC terminal.
The following items could cause the AW to lock up:
•
The MCC terminal is powered down
•
A Reset/Break key or key sequence is inadvertently entered
•
The cables between the MCC and the AW are detached.
This procedure contains steps to restore the AW to operation.
PROCEDURE
1. Verify the MCC terminal is powered on and is properly connected to the Sun
workstation.
2. If an MCC page is displayed, switch to the UNIX
down the Ctrl key and pressing Enter (not Return).
3. Press the RETURN key several times.
If the "ok" prompt appears, proceed to Step 4.
If a "console login:" appears, proceed to Step 9.
4. Type and enter go and press the RETURN key.
Note: May need to type go twice
5. If the "console login:" prompt then appears, switch back to the MCC by holding
down the Ctrl key and pressing Enter (not Return).
6. If the response is "Program terminated," at the "ok" prompt, type and enter: boot
7. Wait for the boot sequence to complete then switch back to the MCC by holding
down the Ctrl key and pressing Enter (not Return).
8. Does the MCC now accept input commands and pokes?
If YES, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, continue.
9. At the login prompt, log in as awadmin, for example.
console login: awadmin
10. From the Administrative Workstation Main Menu, select "Boot the Workstation".
Answer yes to the confirmation. If you select a task by mistake, answer no to the
confirmation.
Response:
You have chose to boot the workstation.
it must be halted before continuing. Refer to the Main Menu ite of
Halt the Emulator.
1. Registered trademark of Sun Microsystems, Inc.
2. Registered trademark in the United States and other countries, licensed exclusively through X/Open
Company, Limited
Issue 3.00
ADMINISTRATIVE WORKSTATION MAINTENANCE
2
console of the AW by holding
If the Emulator is running,
Procedure 4.3
1
Page 4.3-1