Replace The Cajun P333T Ethernet Switch - Lucent 5ESS DRM User Manual

235-200-150
October 2004
3.14

Replace the Cajun P333T Ethernet Switch

Purpose
This procedure is used to replace a defective Cajun P333T Ethernet Switch in the
Lucent Network Component Solution (LNCS) configuration with a replacement Cajun
P333T Ethernet Switch.
When to Use
This procedure is used to replace only a defective Cajun P333T Ethernet Switch. The
replacement of any other Cajun switch model, an ethernet switch of another
manufacturer, or a Cajun P333T Ethernet Switch configured outside the scope of the
LNCS configuration is not supported by this procedure.
Before You Begin
Before replacing the defective Cajun switch, preliminary checks should be performed
to ensure that the cause of failure has not resulted from loss of power to the unit or
the failure of an Ethernet interface cable.
Required Tools
The following equipment is required to perform the procedure:
•
PC with VT100 emulator software or a VT100 terminal configured as follows (see
table 3.14-1):
Issue 3.00L
NETWORK PROCEDURES
Procedure 3.14
Page 3.14-1