Set Up The High Speed Interface To Send Nfm/Scc Data To The 5Ess Switch Host Site - Lucent 5ESS DRM User Manual

235-200-150
January 2003
Set up the High Speed Interface to send NFM/SCC data to the 5ESS
3.8
Host Site
OVERVIEW
The Network Fault Management (NFM) Operational Support System is located near
the host 5ESS Switch. The DRM's total network management (TNM) traffic is routed
back to the host over the TCP-IP network. The connection to the OSS router may
1
beEthernet from the Cajun
and the OSS router must support X.25 over TCP-IP (XOT) functionality. At the DRM,
the High Speed Interface (port 2) is connected to a synchronous port 203 on the
remote router. The remote router and OSS router are programmed with the
destination IP address and port #.
Purpose
Use this procedure to provide access to DRM high speed interface ports by connecting
the ports to the customer operational support services (OSS).
When to Use
The following procedure is used to configure high speed interface to the OSS:
•
after the router has been replaced, or
•
due to a router that is malfunctioning.
Before You Begin
Required Conditions
The following conditions should exist before the procedure is performed:
•
Perform Procedure 8.9, SCC Data Link Growth
•
Verify that the router is connected to the network.
•
Verify that a terminal (laptop computer or VT100 terminal) is connected to the
network.
•
Use Procedure 3.1 to get to the main menu of the unit.
•
To configure the High Speed Interface, access:
— a control display cut-through window, or
— an MCC terminal.
PROCEDURE
3.8.1 Configure the Router at the DRM Site
3.8.1.1 Remotely Log on to the Networking Router
1. Perform Procedure 3.2, to log on to the router locally.
1. Registered trademark of XEROX Corporation.
2. Trademark of AVAYA Communications, Inc.
Issue 3.00
2
P333T from one of the Host routers. The remote router
NETWORK PROCEDURES
Procedure 3.8
®
Switch
Page 3.8-1