Supported Software Releases; Organization - Lucent 5ESS DRM User Manual

INTRODUCTION
to the 5ESS-2000 switch or the 5ESS AnyMedia Switch is also applicable to the 5ESS
switch. It should be noted that this name change may not have been carried forward
into software-influenced items such as input and output messages, master control
center screens, and recent change/verify screens.
1.2.3.3 Bellcore/Telcordia Name Change
As of March 18, 1999, Bellcore officially changed its name to Telcordia Technologies.
Not all pages of this document are being reissued to reflect this change; instead, the
pages will be reissued over time, as technical and other changes are required.
Customers on standing order for this document may see that, on previous-issue pages,
the Bellcore name is still exclusively used.
Customers receiving new orders for this document will see the Telcordia Technologies
name used as appropriate throughout the document, and the Bellcore name used only
to identify items that were produced under the Bellcore name. Exceptions may exist in
software-influenced elements such as input/output messages, master control center
screens, and recent change/verify screens. These elements will not be changed in this
document until such time as they are changed in the software code. Document updates
will not be made specifically to remove historical references to Bellcore.
1.2.4 Lucent Technologies
Lucent Technologies reserves the right to revise this DRM User's Guide for any
reason. The reasons for revision will include, but are not limited to, conformity with
standards promulgated by ANSI
International Telegraph and Telephone Telecommunication Standardization Sector
(TSS), International Standards Organization (ISO), or similar agencies; utilization of
new advances in the state of the technical arts; or to reflect changes in the
requirements of communications systems or equipment.

1.3 ORGANIZATION

This user's guide contains the following sections:
•
Section1 — INTRODUCTION: States the purpose, update information,
supported software releases, and terminology changes.
•
CHAPTER 2 — 5ESS SWITCH DISTINCTIVE REMOTE MODULE: Provides
a description of the DRM including optional terminal interfaces, network
interface, and DRM-specific MCC screens.
•
CHAPTER 3 — NETWORK PROCEDURES: Provides the procedures necessary
to setup and maintain the DRM Network.
•
CHAPTER 4 — ADMINISTRATIVE WORKSTATION MAINTENANCE:
Provides procedures used to maintain the DRM AW.
•
CHAPTER 5 — ROUTINE MAINTENANCE: Provides routine administrative
and maintenance procedures, such as software updates, that are performed on a
regularly scheduled basis.
•
CHAPTER 6 — CORRECTIVE MAINTENANCE: Provides maintenance
procedures that need to be performed when a fault condition warrants
intervention to restore the switching complex equipment to proper operation.
1. Registered trademark of American National Standards Institute.
Page 1-2
1
, Electronic Industrial Association (EIA),
235-200-150
January 2007
Issue 3.00N