Intersecting Axis Gears - SaMASZ KDC 260 Operator's Manual

Tab. 9. Amount of oil to be filled in cutterbar
Mower type
KDC – 2,60 m
KDC - 3,00 m
KDC – 3,40 m
KDC – 3,90 m
KDC – 4,30 m

7.2. Intersecting axis gears

Every day before starting work check the oil level and, if needed, refill after having removed
the vent A on the top of the gear (Fig. 43). The oil level can be checked through check opening B
on the side of the gear. Please refill the oil until it is visible in the check opening. Oil level in gear:
approx. 0.25 U.S.gal. Removing the old oil from the gearbox is done through the outlet
Tab. 10. Amount of oil to be filled in gear
Oil volume
Mower type
[US gal lqd]
All types
approx.
IMPORTANT:
The above instructions should be strictly followed. If the discs in
the cutterbar rotate loosely, do not worry about high intersecting axis gear
temperature; after long working time, it may reach as much as 60-80°C.
C
Fig. 43. Points of check and oil replacement in intersecting axis gears
Operator's manual
Oil volume
[US gal lqd]
1.3
1.6
1.7
1.85
2 x 1.2
Oil type
0.25 SAE 80W/90, API GL-4
A
B
A
C
A
C
- 41 -
Trailed disc mowers
KDC
Oil type Replacement frequency
Once every 3 seasons
80W90
(with intensive operation)
Replacement frequency
(with intensive operation)
A
B
C
B
B
C.
Once every 3 seasons