Tab. 7. Location of centre of gravity
Dimension
[mm]
KDC 260
A
B
Dimension
[mm]
KDC 300
A
4180
B
830
Dimension
[mm]
KDC 340
A
B
Dimension
[mm]
KDC 341
A
B
4.5. Working parts
Before operating the mower, check knife's, knife mounting's and knife holder's condition.
Worn or damaged knives, knife mountings or knife holders should be immediately replaced
with new ones.
4.6. PTO shaft
Before operating, read bar manufacturer's manual placed on the bar. Follow all safety
precautions in that manual.
Use only PTO shafts recommended by mower's manufacturer with guards in good condition.
In order to operate safely, use only undamaged PTO shafts and shields. Damaged PTO shafts
and shields must be repaired or replaced with new ones before use.
4.7. Hydraulic assembly
Hydraulic assembly is under high pressure. Hydraulic oil under pressure may penetrate skin and
cause serious injury or death. Skin and eyes should be protected when working around this
assembly.
In case of injury caused by a liquid under pressure, call a doctor immediately.
Operator's manual
Fig. 5. Location of centre of gravity
KDC 260 S
4150
4420
810
825
KDC 300 S
KDC 300 SL KDC 300 ST KDC 300 SLT KDC 301 W KDC 301 WT
4440
4435
850
855
KDC 340 S
4610
4865
830
850
KDC 341 W
4610
4920
830
805
Trailed disc mowers
Mower type
KDC 260 SL
KDC 260 ST
4415
4720
830
800
Mower type
4750
4750
800
800
Mower type
KDC 340 SL
KDC 340 ST
4860
5200
855
795
Mower type
KDC 341 WT
KDC 390
5270
4190
795
815
- 15 -
KDC
KDC 260 SLT
4720
805
4460
4820
820
800
KDC 340 SLT
5200
795
KDC 430
4700
805