Table of Contents
Advertisement
7.1.
Main frame
The oil level is to be checked periodically through the air-escape valve. The oil level should
be 15 to 20 mm (about ¾ inch) above the bottom. Oil capacity in the gearbox for all types of
the mowers is 5 l. If the checked oil level is low, please check and eliminate any leaks and fill up to
the oil level required.
7.2.
Intersecting axis gear
Every day before starting work please check the oil level and if needed please refill after
having removed the vent on the top of the gear. The oil level can be checked through the check
opening on the side of the gear. Please refill the oil until it is visible in the check opening. The oil
level: about 1 l.
CAUTION:
The above instructions should be strictly followed. If the mowing saucers
rotate loosely, do not worry about the high intersecting axis gear
temperature; after long working time it may reach even 60 - 80
7.3.
Risks present when lubricating
If risk of splashing is present, make sure to wear protective eyewear with side guards.
When lubricating protect eyes and skin against contact with the substance. Therefore use
adequate protective wear with long sleeves and protective footwear. Also use protective gloves.
In case of a contact with skin, immediately wash the infected area with plenty of water with
soap.
Do not allow the product to contaminate water outlets, water courses and soils.
In case of an unintentional release to the environment plug the leak, limit the spillage, and then
collect the oil with non-flammable absorbent material (e.g. sand).
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam,
water mist, extinguishing powders). Do not use water jets.
Disposal of the used product must be made according to official regulations. Improper disposal
of the used oil poses danger to the environment.
Operator's manual
Front drum mower
K2BF 210; K4BF 265; K4BF 300
- 27 -
o
C.
Advertisement
Table of Contents
