Replacing The Water Inlet Or Outlet Temperature Sensor - Huawei NetCol5000-C Series User Manual

NetCol5000-C(065, 080) In-row Chilled Water Smart
Cooling Product
User Manual

6.4.10 Replacing the Water Inlet or Outlet Temperature Sensor

Prerequisites


Context
Temperature sensors can be replaced with power-on.
Recommended tools: utility knife, needle-nose pliers
Preparation: Maintain from the rear door.
Procedure
Step 1 Tap Shutdown on the LCD home screen.
Exercise caution because the device is still energized after it is shut down on the LCD.
Step 2 Open the rear door and remove the air filter.
Step 3 Cut off the thermal insulation foam on the pipe where the sensor is secured.
Step 4 Use the needle-nose pliers to clip out the spring tongue fastening the water inlet or outlet
temperature sensor, and remove the sensor probe, as shown in
Figure 6-9 Position of water inlet or outlet temperature sensor
Step 5 Remove the waterproof connector from the sensor cable.
Issue 07 (2020-03-16)
The water inlet or outlet temperature sensor needs to be replaced.
A spare temperature sensor of the same model is available and functional.
Copyright © Huawei Technologies Co., Ltd.
6 System Operation and Maintenance
Figure 6-9.
166