A24 Window Map Register - National Instruments VXI-MXI User Manual

Register Descriptions

A24 Window Map Register

VXIbus Address:
Attributes:
This register defines the range of addresses in A24 space that are mapped into and out of the
VXI-MXI through the MXIbus. These bits are cleared on a hard reset.
The CMODE bit in the MXIbus Control Register selects the format of this register. If the
CMODE bit is 0 (default), a Base/Size window comparison is used to determine the range of
addresses in the window. If the CMODE bit is set, an upper and lower bound is used to
determine the range of addresses in the window.
The A24 Window Map Register has the following format when the CMODE bit is cleared:
15 14
0 A24EN
A24EN
0
6
7
A24BASE7 A24BASE6 A24BASE5 A24BASE4 A24BASE3 A24BASE2 A24BASE1 A24BASE0
Bit Mnemonic
15r/w 0
14r/w A24EN
13r/w A24DIR
VXI-MXI User Manual
Base Address + E (hex)
Read/Write
13 12
A24DIR 1
0
A24DIR
5 4
Description
Reserved Bit
This bit is reserved and reads back as zero. Write a zero when
writing to these bits.
A24 Window Enable Bit
When this bit is set, the A24 mapping window is enabled. When
this bit is cleared, the A24 mapping window is disabled.
A24 Window Direction Bit
When this bit is set, the A24 window applies to MXIbus cycles that
are mapped into VXIbus cycles (inward cycles). When this bit is
cleared, the A24 window applies to VXIbus cycles that are mapped
out into MXIbus cycles (outward cycles). The complement of the
defined range is mapped in the opposite direction.
11 10
1 A24SIZE2
0 A24SIZE2
3 2
4-18 © National Instruments Corporation
Chapter 4
9 8
R
A24SIZE1 A24SIZE0
A24SIZE1 A24SIZE0
W
1 0
R/W