Lighting The Burners; Safety Instructions; Lighting The Main Burners; Lighting The Side Burner - Barbecook STELLA 3221 User Manual

9

LIGHTING THE BURNERS

To light the burners with the electrical igniter, you have to
0
install an AA battery in the igniter. That battery is not
supplied with the appliance. You find the battery case of
the igniter inside the cabinet of your appliance.

9.1 Safety instructions

• Before you light the appliance, execute all checks listed in
"8 Getting the appliance ready for use".
• Make sure the lid is always open when you light a burner.
• Never bend directly over a burner when lighting it.

9.2 Lighting the main burners

9.2.1 U
SING THE IGNITER
1 Open the lid and set the control knobs of the main burners to
OFF.
2 If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
3 Push in the control knob of one burner, set it to HIGH and
hold it for a moment. The build-in igniter will cause sparks,
which will light the burner.
Always light one main burner to start with. Never light all
1
main burners at the same time.
4 If the burner does not light after three attempts, set its
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
5 Retry lighting the burner. If it still does not light, try lighting it
with a match or refer to "14 Troubleshooting" to determine
the cause of the problem.
9.2.2 U
SING A MATCH
1 Place a match in the match holder.
2 Open the lid and set the control knobs of the main burners to
OFF.
3 If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4 Light the match and hold it about 13 mm from the burner.
5 Set the control knob of one burner to HIGH.
Always light one main burner to start with. Never light all
1
main burners at the same time.
6 If the burner does not light within 5 seconds, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
7 Retry lighting the burner. If it still does not light, refer to
"14 Troubleshooting" to determine the cause of the problem.

9.3 Lighting the side burner

The side burner can only carry vessels with a maximum
1
weight of 9 kg and a maximum diameter of 220 mm.
9.3.1 U
SING THE IGNITER
1 Open the lid and set the control knob of the side burner to
OFF.
2 If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
3 Push in the control knob of the side burner, set it to HIGH
and hold it for a moment. The build-in igniter will cause
sparks, which will light the side burner.
4 If the burner does not light after three attempts, set its
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
5 Retry lighting the side burner. If it still does not light, try
lighting it with a match or refer to "14 Troubleshooting" to
determine the cause of the problem.
www.barbecook.com 11