Code Entry; Service Level - Meiko FV 28G Operating Instructions Manual

15.2 Code entry

To get into the code entry mode, you should keep the key "0" pressed (for around 3 sec-
onds) until you see
on the display unit.
By pressing the key "0" once again you can leave the programming area at any time.
The digit to be modified will flash.
Press the "I" key to increase the value/code indicated on the display unit, or press the "III"
key to decrease it, or press the "accept" key to save it. The next value will then flash and
will be the only one visible.
If your entry is incorrect you will exit the code entry procedure, and the information code
122 will be displayed.
If you enter all the digits correctly you will arrive at the chosen level, either service, config-
uration or machine data.

15.3 Service level

The list of service parameters can be found on this level (parameter numbers 1xx). Here
you can view these or modify them, or you can also call up the ventilation of the rinse and
wash hoses.
On the service level, you will first see the display below:
This corresponds to the viewing/modifying parameters (see 15.3.1)
This corresponds to rinse aid inlet ventilation (see 15.3.2)
This corresponds to detergent inlet ventilation (see 15.3.3)
Press the "I" key to move forwards or the "III" key to move backwards or the "accept" key
to make a selection. You are now at the current level.
You can leave this level by pressing the "0" key.
25 / 44 9625762