Info No.
Description
420
Shortage of rinse aid
520
Shortage of detergent
521
Shortage of detergent with dosing
522
Error in the dosing system ADT
Table 2: Information displays
16.2 Error messages and troubleshooting
Figure 3: Error messages
Error messages will disappear automatically when the fault has been rectified.
Error messages (extract)
ERR.-No. Description
001
EEPROM plug-in fault.
111
Floor pan leakage
112
Dosage leakage
201
Level not reached during 1st fill-
ing
202
Level not reached early enough
during filling
system ADT
37 / 44
Possible cause
If the machine is ready for operation, a
shortage of rinse agent will be signalled
(only if there is a built-in warning sys-
tem).
If the machine is ready for operation, a
shortage of detergent will be signalled
(only if there is a built-in warning sys-
tem).
Impulses of the flow meter are recog-
nized, although the detergent dosing is
not approached. Valve of the dosing unit
is not closing.
Impulses of the flow meter are recog-
nized, although the detergent dosing is
not approached.
Valve of the dosing unit is not closing.
Possible cause
EEPROM not available / incorrectly
plugged in / defective
Empty or incorrect EEPROM
Replace EEPROM with correct parame-
ter set
Leak inside the machine
Pump sump / motor /etc.
Defective leak water switch
Repair fault, remove water
Dosage pump leak
Hose defective / kinked
Defective dosage pump
Defective measurement electrodes
Fresh water inlet insufficient
(water faucet closed)
Aquastop hose kinked
Inlet filter soiled
Aquastop defective
Boiler switch defective
See 201
9625762