Ricoh FAX2900L Service Manual page 213

ERROR CODES
Code
3-20 A SAC signal was received
during ISDN G4
communication
3-21 A CSA was sent during
ISDN G4 communication,
because the Stop key was
pressed
3-30 Mismatched specifications
(rx capability)
4-01 Line current was cut
4-02 The other end cut the
received page as it was
longer than the maximum
limit.
4-10 Communication failed
because of Tel. No./CSI
mismatch (Protection
against Wrong
Connections)
Data reconstruction not
5-00
possible
5-10 DCR timer expired
5-20 Storage impossible
because of a lack of
memory
5-21 Memory overflow
5-22 Mode table overflow after
the second page of a
scanned document
5-23 Print data error when
printing a substitute RX or
confidential RX message
5-24 Memory overflow after the
second page of a scanned
document
5-25 SAF file access error
5-30 Mode table for the first
page to be printed was not
effective
G3 ECM – T1 time out
6-00
during reception of
facsimile data
6-01 G3 ECM - no V.21 signal
was received
6-02 G3 ECM - EOR was
received
Meaning Suggested Cause/Action
The operator at the other terminal may have
interrupted the communication.
The local operator has interrupted the
communication.
Check the receive capabilities requested from
the other terminal.
Check the line connection.
Check the connection between FCU and NCU.
Replace the FCU or the NCU.
Split the page into smaller pieces, or ask the
other end to change their maximum receive
length setting, then resend.
Reprogram the CSIs correctly, then re-send.
The machine at the other end may be defective.
Replace the FCU.
Replace the FCU.
Temporary memory shortage.
Replace the FCU or optional IC card.
Wait for the messages that are currently in the
memory to be sent, or delete some files from
memory.
Ask the other end to re-send the message.
Replace the FCU or IC memory card.
Try using a lower resolution setting.
Wait for the messages that are currently in the
memory to be sent, or delete some files from
memory.
Replace the FCU or IC memory card.
Replace the FCU or IC memory card.
Try adjusting the RX cable equalizer.
Replace the FCU or NCU.
7-32
21 May, 1999