Ricoh FAX2900L Service Manual page 114

BIT SWITCHES
Communication Switch 13
No FUNCTION
0 Immediate transmission:
to Interval between dialing
7 attempts to the same
destination
Communication Switch 14
No FUNCTION
0 mm-to-inch conversion during
transmission
0: Disabled (default)
1: Enabled
1-7 Not used
Communication Switch 15 - Not used (do not change any of these settings)
Communication Switch 16
No FUNCTION
0-1 Not used
2 Optional G4 unit
0: Not installed
1: Installed
3-5 Not used
6 ISDN G3 Reception
0: Enabled
1: Disabled
7 Not used
Communication Switch 17
No FUNCTION
0 SEP (selective polling)
reception
0: Disabled 1: Enabled
1 SUB reception
0: Disabled 1: Enabled
2-7 Not used
Communication Switch 18 - Not used (do not change any of these settings)
Communication Switch 19 - Not used (do not change any of these settings)
Communication Switch 1A - Not used (do not change any of these settings)
COMMENTS
00 - FF (Hex) minutes
COMMENTS
0: Transmitting is always done in mm format.
1: If the other end only has inch-based
resolution for printing, the machine converts the
scanned data to inch-format before
transmission.
Other models use inch-based scanning. In these
models, this setting is inch-to-mm conversion.
Do not change the settings.
COMMENTS
Do not change the settings.
1: Change this bit to 1 when installing the
optional G4 unit.
Do not change the settings.
1: Disables ISDN G3 reception
Do not change the settings.
COMMENTS
0: Disables the SEP (selective polling) signal
reception.
0: Confidential reception to another maker's
machine using the SUB (Sub-address) signal is
disabled.
Do not change the settings.
4-34
21 May, 1999