Ricoh FAX2900L Service Manual page 99

21 May, 1999
System Switch 03
No FUNCTION
0 Length of time that RDS is
to temporarily switched on when
7 bits 6 and 7 of System Switch
02 are set to "User selectable"
System Switch 04
No FUNCTION
0-2 Not used
3 Dedicated transmission
parameter programming
0: Disabled 1: Enabled
4 Inclusion of the Start key in
Keystroke Programs
0: Not needed 1: Needed
5 Not used
6 CSI programming level
0: User level 1: Service level
7
Telephone line type
programming mode
0: User level 1: Service level
System Switch 05
No FUNCTION
0-1 Not used
2 Display of both RTI and CSI
on the LCD
0: Disabled 1: Enabled
3-7 Not used
System Switch 06
No FUNCTION
0 Use of the Stop key during
memory transmission
0: Disabled 1: Enabled
1-3 Not used
4 Use of the Stop key during
memory transmission
0: Disabled 1: Enabled
5 PC Fax Expander option
0: Not installed
1: Installed
6-7 Not used
COMMENTS
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System
Switch 02 are set to "User selectable".
The default setting is 24 hours.
COMMENTS
Do not change these settings.
Set this bit to 1 before changing any dedicated
transmission parameters.
0: The user does not need to press the Start key
when operating a keystroke program.
Do not change the settings.
1: Only a service function can program the CSI.
1: Only a service function can program the
telephone line type selection.
COMMENTS
Do not change these settings.
1: Both RTI and CSI will be displayed alternately
on the LCD.
Do not change these settings.
COMMENTS
1: The Stop key can be used to halt memory
transmissions. However, users might
accidentally cancel another person's memory
transmission in progress.
Do not change these settings.
1: The Stop key can be used to halt memory
transmissions. After pressing the Stop key, a
message (STOP & CLR FILE?) appears on the
LCD.
Change this bit to 1 when installing the PC Fax
Expander option.
Do not change these settings.
4-19
BIT SWITCHES