Ricoh FAX2900L Service Manual page 136

SERVICE RAM ADDRESSES
8000A2(H) - User parameter switch 02
Bit 0: Forwarding mark printing on forwarded messages 0: Disabled, 1: Enabled
Bit 1: Center mark printing on received copies
Bit 2: Reception time printing
Bit 3: TSI included in transmitted messages
Bit 4: Checkered mark printing
Bit 5: CIL printing (G4)
Bit 6: TID printing (G4)
Bit 7: Not used
8000A3(H) - User parameter switch 03 (Automatic report printout)
Bit 0: Transmission result report (memory transmissions) 0: Off, 1: On
Bit 1: Not used
Bit 2: Memory storage report
Bit 3: Polling reserve report (polling reception)
Bit 4: Polling result report (polling reception)
Bit 5: Transmission result report (immediate transmissions)
Bit 6: Polling clear report
Bit 7: Journal
8000A4(H) - User parameter switch 04
Bit 0: Confidential reception report
Bits 1 to 6: Not used
Bit 7: Includes a sample image on reports
8000A5(H) - User parameter switch 05
Bit 0: Substitute reception
Bit 1: Memory reception if no RTI or CSI received
Bits 2 to 5: Not used
Bit 6: Fusing lamp control during energy saver mode
Bit 7: Not used (keep this bit at 0.)
8000A6(H) - User parameter switch 06
Bit 0: TTI
Bit 1: Not used
Bit 2: Closed network for transmission
Bit 3: Not used
Bit 4: Batch transmission
Bit 5: Not used
Bit 6: ISDN SPID programming (used only in the USA)
Bit 7: Not used
8000A7(H) - User parameter switch 07
Bits 0 to 1: Not used
Bit 2: Parallel memory transmission
Bit 3: Not used
Bit 4: Use of ∗ key for tonal signals
Bits 5 to 7: Not used
0: Possible, 1: Impossible
0: Lamp off, 1: Standby temperature
4-56
21 May, 1999
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
0: Disabled, 1: Enabled
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On
0: Off, 1: On