Ricoh FAX2900L Service Manual page 138

SERVICE RAM ADDRESSES
8000AB(H) - User parameter switch 11 (SWusr_0B)
Bit 0: Not used
Bit 1: Method of transmitting numbers after the "Tone" mark over an ISDN line
Bit 2: Blank sheet detection
Enabled
Bits 3 to 5: Not used
Bit 6: Printout of messages received while acting as a forwarding station
Bit 7: Polling Standby duration
8000AC(H) - User parameter switch 12 (SWusr_0C)
Bit 0 to 6: Not used
Bit 7: Copy operation
8000AD(H) - User parameter switch 13 (SWusr_0D)
Bits 0 and 1: PSTN access method from behind a PABX
Bit 1 0
0 0
0 1
1 0
1 1
Bit 1: Receive message in the memory when the machine is set as PC direct
reception and the PC does not receive the message
Bits 2 to 5: Not used
Bit 6: Action when the received Higher Layer Capabilities is Tel or Bearer
Capabilities is Speech
(This switch is not listed on the User Parameter List.)
Bit 7: Not used
8000AE(H) – User parameter switch 14 (SWusr_0E)
Bit 0: Transmission method
Bit 1: To print received messages (normal fax reception) if the PC does not
respond in the PC direct reception mode
0: Do not print the message
1: Print the message when the number of rings exceeds the counter
Bit 2: TTI included in memory transmission (when bit 0 is set to "1")
Bit 3 and 4: Destination for reception
Bit 4 3 Destination
0 0 Print from the machine (normal fax reception)
0 1 PC direct reception
1 0 PC memory reception
1 1 PC memory reception and print from the machine
Setting
PSTN
Loop start
Ground start
Flash start
0: Off, 1: On
0: Once, 1: No limit
0: Possible, 1: Prohibited
0: Do not receive in the memory
1: Receive in the memory
0: Do not respond to the call
1: Respond to the call
0: Direct
0: Disabled 1: Enabled
4-58
21 May, 1999
0: UUI, 1: Tone
0: Disabled, 1:
1: Memory