Table of Contents
Advertisement
9. OTHER SETTINGS
9.2.8
[Net SONDE Setting] menu
The [Net SONDE Setting] menu sets up the net sonde. To show this menu, open the
[Mark & Operation Support Tool] menu, then select [7 Net SONDE Setting].
The settings for [1 Number of XMTR], [2 XMTR Distance] and [3 Net Length] are inter-
related and the number of sonde/distance between transmitters is restricted by the net
length. For this reason it is recommended to use the following order when setting up
your transmitters (sondes). Set [3 Net Length] → set [1 Number of XMTR] → [2 XMTR
Distance]. If your net has more transmitters than available on the menu, reduce at
least one of the settings at [2 XMTR Distance] to [0m], then set the correct number of
transmitters at [1 Number of XMTR].
[1 Number of XMTR]: Sets the number of transmitter units used, from 0 to 10. When
the total value of [2 XMTR Distance] is smaller than the setting value of [Net Length],
max. 10 transmitter units can be used.
[2 XMTR Distance]: Sets the distance between transmitters. Select this item then
push the left-click button to set the distances. The setting range is 0 to 1000 m (de-
pending on the setting at [3 Net Length]). This setting cannot be changed while nets
are out.
[3 Net Length]: Sets net length in increments of 100 m. Setting range is 1200 m to
3000 m.
[4 Depth Display]: Selects which sonde depth data to show. Select this item and push
the left-click button to select net sondes. The check mark shows current selection
(Max. 3).
9-9
Advertisement
Table of Contents
