Fish Finder Mode; Basic Operating Procedure - Furuno FSV-75 Operator's Manual

4.

FISH FINDER MODE

This equipment can show the picture from the fish finder in combination with the sonar
echoes.
Note: Requires connection of an fish finder.
4.1

Basic Operating Procedure

Turn the power on.
Adjust reange, gain and picture advanse speed on the menu.
Note: In the default setting, slant (S) and vertical Slant (VCS) modes are active. To
use other display modes, register the display mode to use from the menu. For how to
register display modes, see section 1.6.2.
Lower the transducer.
• If the mid protrusion key is programmed to [Fixed Position]:
Lowers the transducer to half protrusion.
• If the mid protrusion key is programmed to [Any Position]:
The transducer stops at desired position.
• If the mid protrusion key is programmed to [Fixed Position]:
Lowers the transducer to full protrusion.
• If the mid protrusion key is programmed to [Any Position]:
The transducer stops at desired position.
Select appropriate fish finder mode (S & FF, VCV & FF, 3D & FF).
4-1