Table of Contents
Advertisement
3.8.7
Reverberation
You can choose the length of reverberation for the echo signal, with [4 Reverberation]
(located at main menu → [1 TX/RX Setting]. Adjusting the reverberation can compen-
sate for echoes from plankton, surface reflections and seabed echoes. The settings
available are [0] or [1]. The [0] setting is functional at range within 100 m. If you select
[1], the reduction in reverberation is larger. Select the appropriate setting for your
needs.
3.8.8
Echo average
The echo average function adjusts echo afterglow - the amount of time an echo signal
remains on the screen. This feature can be useful for watching echo movement
You can adjust the echo average from either of the following menus, depending on
your requirements: Main menu → [4 Picture Setting] → [1 Echo Average] or [6 Auto
Sweep Echo AVG]. The setting range is [0] to [11].
Settings between [1] and [7]: Echoes are gradually displayed and afterglow remains
on the screen longer as the setting is increased.
Settings between [8] and [11]: Echoes are quickly displayed and afterglow remains
on the screen longer as the setting is increased.
Adjust [1 Echo Average] for regular use; adjust [6 Auto Sweep Echo AVG] for echo
averaging while the auto sweep function is active. The setting for both items should
be the same.
3.8.9
2nd echo rejection
A target that is farther than the repetition interval of transmission may appear as a vir-
tual image on the screen one time later. This is called secondary echo. Reflections
from tracks are so strong that secondary echoes appear easily. To remove secondary
echoes, set [9 2nd Echo Reject] (located at main menu → [4 Picture Setting]) to other
than "0" (OFF).
3.9
How to Adjust Beam Width
The width of the horizontal beam on the S-display can be adjusted from the [Beam
Width] menu.
1. Open the menu.
2. Select [1 TX/RX Setting], then left-click.
3. Select [7 Beam Width], then left-click.
4. Left-click the
The setting range is [0] to [4]. A higher setting gives a narrower beam.
5. Select [Quit], then left-click.
6. Close the menu.
or
button to select the desired setting.
3. VERTICAL SLANT MODE
3-13
Advertisement
Table of Contents
