Text Overlay Setting; Take Button - RGBlink GX4 Quick Start Manual

Hide thumbs Also See for GX4:

Table of Contents

Refer to the zoom Settings for details.

At this point, the button 0~9 digital button lamp is on, and users can set it through the knob or digital button.

Text Overlay Setting

Before setting the text overlay, please make sure the input channel of the text. For example, set VGA input as

the text channel. Then make sure the channel that the text will overlay, for example, overlay the text on DVI

channel. The operations are as follows:

1. Push the VGA button to make sure there is VGA input.

2. Push the DVI button to make sure there is DVI input.

3. Push the [MENU] button, turn the rotary knob, select <PICTURE>, push the knob to confirm, turn the rotary

knob, and select <TEXT OVERLAY>, push the knob to confirm.

Then enter into TEXT OVERLAY menu items, turn the rotary knob, and select <TEXT OVERLAY>, push the knob

to confirm, turn the rotary knob again, and select "ON" to enable the text overlay function.

4. Make sure VGA input is IMAGE B, and DVI input is IMAGE A, if not, select <SWAP WINDOW> option by

pushing [PIP] button, and select "ON" for <SWAP WINDOW>.

5. Select the VGA image in "IMAGE B" in <SELECT> option by pushing <PIP> button, and push [SCALE] button to

adjust the size and position of VGA image, then set the VGA image to the required position.

The standard position and size is: ensure the VGA image overlay on the DVI image, display normally and

without black edges. If there are black edges around VGA image, select <ZOOM> option in <INPUT> to adjust.

6. Set the text overlay mode: select <PRESET> option in <TEXT OVERLAY>, push the knob to enter into the

<PRESET> menu items. Turn the rotary knob to select the preset mode, for example, set the VGA text as

WhOnBk, choose WhOnBk1 or WhOnBk2 (Note: Text Overlay only support monochrome subtitles), user can

also adjust the <BLEND MODE> or <BLEND LEVEL> to get a better effect.

7. Push the [SAVE/1] button to save the above parameters.

1.The default of system is turn on the button"TAKE"

2. Select the signal that need to take, for example, gently push [DVI/5] button, the signal source button turns

blinking ,and the OLED screen will display the selected TAKE signal source;

. Pressing 5 seconds frequently can be able to cancel the selection of the "TAKE" key.

4.After select the signal, push the [TAKE], and the signal will be taken to the output in the way of special effect.

Ph: +86 592 5771197 |

support@rgblink.com

www.rgblink.com

12 / 20

Table of Contents