Racelogic Speed & Route Profiler Manual page 14

Fixed Speed
Long distance
Certain tests require a driver to remain at a fixed speed over a long distance, perhaps on a motorway. Whilst
the Reference driver may attempt to maintain this speed, it may prove difficult, due perhaps to slow moving
traffic, yet it is required for the driver to try to maintain this fixed speed where possible.
It is possible to set this up within the software by setting a fixed speed between two points. First you will
need to select the start point by clicking on the nearest point in the route summary , this will show in more
detail on the detail map. Next scroll around the detail map to identify the exact start point for the fixed
speed section and double click to centre the map on this position. Then mark the start point, by holding the
shift key down whilst pressing the S key (Shift + S). Now do the same thing to find the end point for this fixed
speed section. Double click to centre the map again, but this time press Shift + E. You will notice a small
yellow triangle appearing at both the start and end point on the route summary, see summary map below.
Now press the spacebar to bring up a speed profile between the start and end points. You will see a Speed
Editor box appear, just enter the speed that you wish to maintain in this box. Then press Save to save this
speed profile.
Once the SPD file has been created, any GPS dropouts are repaired and any speed adjustments made, you
are now ready to download the file into the OLED display. See page 18 COMM Ports.
17/11/2010 |14