Install The Gauge Wheels; Mount The Gauge Wheels - Raven AutoBoom Installation Manual

Install the Gauge Wheels

Mount the Gauge Wheels

Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location
for mounting wheels on the boom, ensuring they will not interfere with or be damaged by folding or unfolding
the booms. The wheel should be mounted outside of the boom fold, but inside of the boom breakaway.
Note:
The appearance of the wheel axles will vary, depending on the wheel axle kit that was ordered
with the AutoBoom system.
Gauge Wheel Installed
FIGURE 8.
Remove the lug nuts from the right wheel axle.
1.
Place the wheel (P/N 322-0131-008) on the right wheel axle.
2.
Reinstall the lug nuts on the wheel axle to secure the wheel.
3.
Attach the right wheel mounting bracket (P/N 116-0159-658) to the back of the right boom by installing four
4.
2-1/16" W x 3" L x 3/8" thread U-bolts (P/N 107-0171-609) through the back of the mounting bracket and
securing them with eight 3/8" zinc flanged lock nuts (P/N 312-1001-164).
Insert the left wheel axle into the left wheel mounting bracket, positioning it so that the bottom of the wheel
5.
touches the ground (or nearly so) and the wheel faces away from the machine.
Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex
6.
bolts (P/N 311-0058-186) and two 1/2" zinc hex nuts (P/N 312-1001-043).
Repeat the steps above to install the right wheel.
7.
Manual No. 016-023-071
WARNING
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
PowerGlide
15