Convert The Sprayer's Hydraulic Valve To Open Center (If Applicable); Install Fittings On The Autoboom Valve - Raven AutoBoom Installation Manual

Convert the Sprayer's Hydraulic Valve to Open Center (If
Applicable)
By factory default, the machine's main hydraulic valve is configured as an "open center" hydraulic system.
However, if the hydraulic valve has been converted to a "closed center" system, it will have to be changed back
to the "open center" configuration. Complete the following steps to convert the machine's hydraulic system
from a "closed center" to "open center" system.
Note:
The machine came equipped from the factory with a master open center coil that is necessary to
convert the hydraulic valve. If the master open center coil has been misplaced, a replacement
must be obtained from the dealer from whom the machine was purchased.
Converted Hydraulic Valve - Closed Center to Open Center
FIGURE 1.
Closed Center Valve
Locate the master open center coil port on the machine's hydraulic valve.
1.
Remove the cavity plug installed in the master open center coil port.
2.
Install the master open center coil in the machine's hydraulic valve.
3.

Install Fittings on the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the proper fittings on the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following
figure and table to install the fittings in the appropriate ports of the AutoBoom valve.
Fitting - 9/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" SAE O-Ring (M) to 3/4" JIC (M) Straight Adapter
Fitting - 9/16" JIC M/F 90° Swivel Elbow
Manual No. 016-023-071
Fitting
PowerGlide
Open Center Valve
Part Number Port
LC, RC
333-0012-045
LV, RV
333-0012-093 P, T, EF
333-0012-042 LC, RC
9